All Categories

  • All Categories
  • 3D PRINTING
  • INTERNET OF THINGS
  • Modules
  • ROBOTICS & CNC
  • SENSORS & MODULES
  • STARTER & DIY KITS

CNC 2-Phase Stepper Motor Driver, ST-DM542

  • $29.99
  • Ex Tax: $29.99
  • Product Code: 101-60-268
  • Availability: In Stock

SPECIFICATION: +V: DC Power positive terminalGND: DC Power negative terminalA+、A-: Stepping motor one windingB+、B-: Stepping motor other windingPUL++5V-24V、PUL -: Stepping pulse input (Rising edge effective, Pulse width >1.2 us)DIR ++5V-24V、DIR-: Direction signal input, high level forward, low level reverse, the direction of signal shoul..

SPECIFICATION:
  • +V: DC Power positive terminal
  • GND: DC Power negative terminal
  • A+、A-: Stepping motor one winding
  • B+、B-: Stepping motor other winding
  • PUL++5V-24V、PUL -: Stepping pulse input (Rising edge effective, Pulse width >1.2 us)
  • DIR ++5V-24V、DIR-: Direction signal input, high level forward, low level reverse, the direction of signal should be at least 5 us ahead of the pulse signal.
  • ENA++5V-24V、ENA-: motor free
  • Green LED: Power LED
  • Red LED : Fault indication, over current、 overvoltage 、or other failures. The red LED light is bright, after the failure is eliminated, Power off for a while and then power, the red LED lamp is out
WHAT'S IN THE PACKAGE

ST-DM542 X 1

Paper specification

    There are no reviews for this product.

    Write a review

    Note: HTML is not translated!
        Bad           Good